This symbol points out important safety instructions, which, if not followed, could endanger the personal safety and/orproperty of yourself and others
Generac Portable Products Power Transfer System10INSTALLATION AND LOAD MANAGEMENT NOTES
Generac Portable Products Power Transfer System11LOAD MANAGER SCHEMATIC DIAGRAM
Generac Portable Products Power Transfer System12Item Part No. Qty. Description1 20030 1 COMPLETE ENCLOSURE,Front & Back2 39271 1 CONNECTOR, 90 De
Generac Portable Products Power Transfer System13OPERATING PROCEDUREThis manual section describes the routine proceduresused by the owner to operate t
Generac Portable Products Power Transfer System146. At the Load Manager switches, move desiredcircuit switches from LINE position to GENposition
Generac Portable Products Power Transfer System15TROUBLESHOOTINGProblem Cause SolutionGenerator is running, but noAC output is available.1. Generator
LIMITED WARRANTYOne Year Limited WarrantyGenerac Portable Products (hereafter referred to as the COMPANY), warrants to the original purchaser that thi
Generac Portable Products Power Transfer System2NOTE: The maximum load allowed through eachLoad Manager switch is 7200 Watts: 30 Amps at240 Volts or
Generac Portable Products Power Transfer System3GENERAL SAFETYINFORMATION1. A licensed electrician or qualified professional(referred to herein as in
Generac Portable Products Power Transfer System4INSTALLATIONPROCEDURELoad Manager SwitchBefore removing the load center cover, plan mountinglocation
Generac Portable Products Power Transfer System56. From the load management plan, determine theload that is to be connected to Load Managerswitch cir
Generac Portable Products Power Transfer System611. If a two-pole circuit is not needed, the two-polecoupled switch can be converted into two single-p
Generac Portable Products Power Transfer System7Connection BoxThe installer should use local codes and the followingprocedure to install the generator
Generac Portable Products Power Transfer System818. Referring to Figure 13, remove the connection boxinner panel. Mount the connection box at itsplann
Generac Portable Products Power Transfer System921. As shown in Figure 15, trim, strip, and connecteach wire to the appropriate terminal on thelocking
Comments to this Manuals